Triple Battery Charger B2B 60A, AC-DC 40A,MPPT Solar 430W

INSTALLATION ATTENTION
• Do not expose the triple charger to rain or snow.
• Do not use the triple charger if it has received a sharp blow, been dropped,
has cracks or openings in the case, or is damaged in any other way.
• Do not install the charger near a heat source.
• This charger should not be installed in an airtight or poorly ventilated area.
• Do not attempt to open the triple charger. There are no user serviceable parts
except for user replaceable fuses.
• Do not use the triple charger with damaged cables.
• It is strictly forbidden to disassemble the charger and/or modify the housing in
any way.

CONNECTIONS ATTENTION
• It is important to choose the correct battery type, a wrong choice can cause irreversible
damage, The LITHIUM charging cycle is only compatible with LiFePo4 batteries with
integrated BMS (Battery Management System).
Maintenance
• If necessary, the fuses must be replaced by identical products.
• This charger cannot be disassembled and the electronic board is inaccessible.
• Therefore, with the exception of the fuses, all on-site maintenance is prohibited.
• Disconnect the DC power supply before servicing, cleaning or working on
circuits connected to the DC/DC booster.
• Strongly recommend AC input source with grounding wire
• It is important to ensure that the area around the battery is well ventilated.
• It is important to ensure that the battery voltage matches the output voltage
• Always use ungrounded batteries. If necessary, the battery grounding connection
should be made last.
To prevent overheating, make sure the connections are properly tightened.